Tail Lamp Replacement (Chevrolet Tahoe Two-Mode Hybrid)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Tail Lamp Assembly & Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Open the liftgate in order to access the light emitting diode (LED) tail lamp assembly screws.
1	Tail Lamp Assembly Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
2	Tail Lamp Electrical Harness Assembly Connector TIP: Disconnect the tail lamp electrical connector from the rear tail lamp assembly.
3	Tail Lamp Assembly TIP: Upon installation, push inward on the outer edge of the tail lamp in order to seat the 2 locating pins to the outer body panel nuts prior to installing the screws.