LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 439 (Lighting System) >> Repair Instructions >> Spot Lamp Bulb Replacement (RPO 7X6, 7X7) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Spot Lamp Wiring Harness Push-In Retainer & Electrical Connector
    GM556316Courtesy of GENERAL MOTORS COMPANY
  1. Remove the spot lamp wiring harness push-in retainer from the windshield garnish molding, using a small flat bladed tool.
  2. Disconnect the electrical connector.
    3. Fig 2: Locating Spot Lamp Bezel Screw (RPO 7X6, 7X7)
    GM899866Courtesy of GENERAL MOTORS COMPANY
  3. Remove the screw from the spot lamp bezel.
    4. Fig 3: Removing Spot Lamp Bezel (RPO 7X6, 7X7)
    GM899868Courtesy of GENERAL MOTORS COMPANY
  4. Remove the spot lamp bezel from the spot lamp.
    5. Fig 4: Removing Lamp From Spot Lamp (RPO 7X6, 7X7)
    GM557428Courtesy of GENERAL MOTORS COMPANY
  5. Remove the lamp from the spot lamp.
    6. Fig 5: Removing Spot Lamp Retaining Clip (RPO 7X6, 7X7)
    GM899869Courtesy of GENERAL MOTORS COMPANY
  6. Remove spot lamp bulb retaining clip.
    7. Fig 6: Removing Spot Lamp Bulb From Spot Lamp (RPO 7X6, 7X7)
    GM899870Courtesy of GENERAL MOTORS COMPANY
  7. Remove the spot lamp bulb from the spot lamp.
    8. Fig 7: Disconnecting Spot Lamp Bulb Electrical Connector (RPO 7X6, 7X7)
    GM899872Courtesy of GENERAL MOTORS COMPANY
  8. Disconnect the spot lamp bulb electrical connector.
scientia non olet · About LEMON Manuals