LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 439 (Lighting System) >> Repair Instructions >> Spot Lamp Bulb Replacement (RPO 7X6, 7X7) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting Spot Lamp Bulb Electrical Connector (RPO 7X6, 7X7)
    GM899872Courtesy of GENERAL MOTORS COMPANY
  1. Connect the spot lamp bulb electrical connector.
    2. Fig 2: Removing Spot Lamp Bulb From Spot Lamp (RPO 7X6, 7X7)
    GM899870Courtesy of GENERAL MOTORS COMPANY
  2. Install the spot lamp bulb to the spot lamp.
    3. Fig 3: Removing Spot Lamp Retaining Clip (RPO 7X6, 7X7)
    GM899869Courtesy of GENERAL MOTORS COMPANY
  3. Install the spot lamp bulb retaining clip.
    4. Fig 4: Removing Spot Lamp Bezel (RPO 7X6, 7X7)
    GM899868Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The spot lamp assembly must be clocked in the UP position, refer to the emblem on the face of the lamp.

  4. Holding the spot lamp in position, install the spot lamp bezel to the spot lamp.
    5. Fig 5: Locating Spot Lamp Bezel Screw (RPO 7X6, 7X7)
    GM899866Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  5. Install the spot lamp bezel screws and tighten to 2 (18 lb in).
    6. Fig 6: Spot Lamp Wiring Harness Push-In Retainer & Electrical Connector
    GM556316Courtesy of GENERAL MOTORS COMPANY
  6. Using a small flat-bladed tool, install the spot lamp wiring harness push-in retainer to the windshield garnish molding.
  7. Connect the electrical connector.
  8. Inspect the spot lamp for proper operation.
scientia non olet · About LEMON Manuals