Rear Fog Lamp Replacement (Cadillac Export)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Tail Lamp Assembly & Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Open the liftgate in order to access the left tail lamp assembly screws.
1	Tail Lamp Assembly Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in)
2	Tail Lamp Assembly Locator Pin (Qty: 2) TIP: Upon tail lamp removal, some effort is needed to disengage the locating pins from the rear body panel retainer nuts.
3	Tail Lamp Retainer Nut (Qty: 2)
4	Tail Lamp Wiring Harness Assembly Connector
5	Tail Lamp Assembly The bottom bulb in the left tail lamp is the rear fog lamp bulb and will have a red lens. This is an export only item. Upon installation, push inward on the tail lamp in order to seat the 2 locating pins.