LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 439 (Lighting System) >> Repair Instructions >> Brake Pedal Position Sensor Replacement (With JF4) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the ignition switch in the OFF position.
  2. Disconnect the brake pedal position sensor electrical connector.
    3. Fig 1: Brake Pedal Position Sensor Bolt
    GM2683511Courtesy of GENERAL MOTORS COMPANY
  3. Remove the brake pedal position sensor bolt (1).
    4. Fig 2: Brake Pedal Position Sensor
    GM2683535Courtesy of GENERAL MOTORS COMPANY
  4. Remove the brake pedal position sensor (1).
scientia non olet · About LEMON Manuals