LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 439 (Lighting System) >> Diagnostic Information and Procedures >> Headlamps Malfunction (With X88, Z75, and Z88) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the scan tool Headlamp Switch parameter while turning the headlamp switch ON and OFF. The reading should change between Active and Inactive.
    • If the reading does not change between the specified values, refer to Headlamp Switch Malfunction.
  2. Observe the scan tool Auto Hdlp. Disable Sw. parameter while turning the headlamp switch ON and OFF. The reading should toggle between Active and Inactive.
    • If the reading does not change between the specified values, refer to Headlamp Switch Malfunction.
  3. Observe the scan tool Flash to Pass Switch parameter while applying and releasing the turn signal/multifunction switch. The reading should toggle between Active and Inactive.
    • If the reading does not change between the specified values, refer to Turn Signal/Multifunction Switch Malfunction.
  4. Observe the scan tool High Beam Select Switch parameter while applying and releasing the high beam select switch. The reading should toggle between Active and Inactive.
    • If the reading does not change between the specified values, refer to Turn Signal/Multifunction Switch Malfunction.
  5. Command the Low Beams ON and OFF with a scan tool. The low beam headlamps should turn ON and OFF when commanded.
    • If the low beam headlamps do not turn ON and OFF when commanded, refer to Headlamps Malfunction - Low Beam.
  6. Command the DRLs ON and OFF with a scan tool. The daytime running lamps should turn ON and OFF when commanded.
    • If the low beam headlamps do not turn ON and OFF when commanded, refer to Headlamps Malfunction - Daytime Running Lamps.
  7. Command the High Beams ON and OFF with a scan tool. The high beam headlamps should turn ON and OFF when commanded.
    • If the high beam headlamps do not turn ON and OFF when commanded, refer to Headlamps Malfunction - High Beam.
  8. Command the Lamp Test ON and OFF with a scan tool. The lights on indicator and high beam indicator should turn ON and OFF when changing between the commanded states.
    • If the lights on indicator and high beam indicator illuminate during the test, replace the BCM.
    • If the lights on indicator and high beam indicator do not illuminate during the test or remain illuminated at all times, replace the instrument cluster.
scientia non olet · About LEMON Manuals