LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 439 (Lighting System) >> Diagnostic Information and Procedures >> Daytime Running Lamps Malfunction (With Z88, Z75, and Z88) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, Headlamps OFF, command the Low Beams ON and OFF with a scan tool. The low beam headlamps should turn ON and OFF when changing between the commanded states.
  2. Headlamps OFF, command the DRL ON and OFF with a scan tool. The daytime running lights should turn ON and OFF when changing between the commanded states.
    • If the daytime running lights do not change between the commanded states, refer to Daytime Running Lamp Malfunction.
  3. Observe the scan tool Ambient Light Status parameter while supplying sufficient light to simulate daylight conditions to the ambient light sensor. After 30 seconds, the parameter should be Day.
    • If not the specified value, refer to Ambient Light Sensor Malfunction.
scientia non olet · About LEMON Manuals