LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Object Detection System - Park Assist System) >> Diagnostic Information and Procedures >> DTC B0958, B0959, B0960, or B0961 >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

B0958 01, B0959 01, B0960 01, or B0961 01 

Voltage seen on the object alarm sensor signal circuit is greater than 11.5 V or the object alarm sensor is not grounded.

B0958 06, B0959 06, B0960 06, or B0961 06 

Voltage seen on the object alarm sensor signal circuit is less than 0.5 V.

B0958 08, B0959 08, B0960 08, or B0961 08 

An invalid signal is received by the object alarm module.

B0958 21, B0959 21, B0960 21, or B0961 21 

The object alarm sensor determines no change in the position of an object while the vehicle is in motion.

B0958 3A, B0959 3A, B0960 3A, B0961 3A 

The object alarm module determines there is an incorrect sensor installed.

scientia non olet · About LEMON Manuals