Pickup Box Endgate Latch Handle Bezel Replacement (Pickup)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Pickup Box Endgate Latch Handle Bezel (Pick Up)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Pickup Box Endgate Latch Handle Bezel Bolt CAUTION: Refer to Fastener Caution . Procedure Remove the bolt prior to releasing the latch handle bezel from the endgate outer panel. Tighten 22 N.m (16 lb ft)
2	Pickup Box Endgate Latch Handle Bezel Procedure Release the 3 retainer clips securing the bezel to the endgate outer panel. Lift the endgate latch handle in order to aid in the removal of the latch handle bezel. Disconnect the rearview camera, if equipped. Refer to Rearview Camera Replacement (Endgate) , Rearview Camera Replacement (Liftgate) .

Callout

Component Name

Pickup Box Endgate Latch Handle Bezel Bolt

CAUTION:

Refer to Fastener Caution .

Procedure
Remove the bolt prior to releasing the latch handle bezel from the endgate outer panel.
Tighten
22 N.m (16 lb ft)

Pickup Box Endgate Latch Handle Bezel

Procedure

Release the 3 retainer clips securing the bezel to the endgate outer panel.
Lift the endgate latch handle in order to aid in the removal of the latch handle bezel.
Disconnect the rearview camera, if equipped. Refer to Rearview Camera Replacement (Endgate) , Rearview Camera Replacement (Liftgate) .