Liftgate Emblem/Nameplate Replacement (Suburban FFU)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Liftgate Emblem/Nameplate

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Flex Fuel Badge CAUTION: Refer to Exterior Trim Emblem Removal Caution . The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength. Use a J-25070 Heat Gun or equivalent to remove the old emblem. Clean all adhesive from rear liftgate and wipe the surface dry with a clean lint-free towel prior to installing the new emblem/nameplate. When removing protective liners from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion. Close the liftgate. Wet out the emblem and ensure full adhesion of the emblem to the liftgate is made. Special Tools J-25070 Heat Gun

Callout

Component Name

Flex Fuel Badge

CAUTION:

Refer to Exterior Trim Emblem Removal Caution .

The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
Use a J-25070 Heat Gun or equivalent to remove the old emblem. Clean all adhesive from rear liftgate and wipe the surface dry with a clean lint-free towel prior to installing the new emblem/nameplate.
When removing protective liners from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
Close the liftgate.
Wet out the emblem and ensure full adhesion of the emblem to the liftgate is made.

Special Tools
J-25070 Heat Gun