Liftgate Center Applique Replacement (Tahoe, Yukon)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Liftgate Center Applique Assembly & Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Open and support the liftgate assembly. Remove the rear wiper motor. Refer to Rear Window Wiper Motor Replacement . Do Not Use Air-Type Power Tools when Performing the Following Steps: Use a needle-nose type vice grip plier and ratchet type wrench. Hold the very end of the applique studs secure. Slowly ratchet the nut from each of the applique studs. Use the access holes in the panel to access and remove the nuts. Remove the 4 applique nuts from inside the liftgate panel. Using a 8 mm socket, push the socket onto the retainers in order to release the retainer ears from the inner panel. Pull and remove the liftgate center applique from the exterior side of the body panel. Disconnect all electrical connections.
1	Liftgate Center Applique Assembly Nut (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 6 N.m (53 lb in)
2	Liftgate Center Applique Harness Grommet TIP: Ensure the grommet is secure to the liftgate panel hole prior to the installation of the applique.
3	Liftgate Center Applique Assembly TIP: Transfer the rearview camera, if equipped. Refer to Rearview Camera Replacement (Endgate) , Rearview Camera Replacement (Liftgate) .