Decal or Stripe Replacement (Tahoe Hybrid 2 Mode Windshield)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Decal Or Stripe Location

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Heat the decal using a J-25070 gun or equivalent, 152 mm (6 in) from the glass surface. Apply the heat using a circular motion, for about 30 seconds. CAUTION: Refer to Exterior Trim Emblem Removal Caution . Remove the decal from the surface using a plastic, flat-bladed tool. Remove all adhesive from the surface using a 3M™ Scotch Brite molding adhesive remover disk, 3M™ P/N 07501, or equivalent. Clean the surface using 3M™ General Purpose Adhesive Cleaner, P/N 08984 or equivalent. Special Tools J-25070 Heat Gun 500-750°F
1	HYBRID Windshield Glass Decal TIP: The windshield glass decal is serviced as one part.

Callout

Component Name

Preliminary Procedures

Heat the decal using a J-25070 gun or equivalent, 152 mm (6 in) from the glass surface.
Apply the heat using a circular motion, for about 30 seconds.

CAUTION:

Refer to Exterior Trim Emblem Removal Caution .

Remove the decal from the surface using a plastic, flat-bladed tool.
Remove all adhesive from the surface using a 3M™ Scotch Brite molding adhesive remover disk, 3M™ P/N 07501, or equivalent.
Clean the surface using 3M™ General Purpose Adhesive Cleaner, P/N 08984 or equivalent.

Special Tools J-25070 Heat Gun 500-750°F

HYBRID Windshield Glass Decal
TIP: The windshield glass decal is serviced as one part.