Replacement Wheels Description

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Replace the wheel if any of the following conditions exist:

The wheel exhibits excessive runout.
The wheel is bent.
The wheel is cracked.
The wheel is severely rusted.
The wheel is severely corroded.

NOTE:

Air leaks caused by porosity on aluminum wheels are repairable.

WARNING:

If you are replacing the wheel(s), the wheel stud(s), the wheel nut(s) or the wheel bolt(s), install only new GM original equipment parts. Installation of used parts or non-GM original equipment parts may cause the wheel to loosen, loss of tire air pressure, poor vehicle handling and loss of vehicle control resulting in personal injury.

The wheel leaks air.

CAUTION:

The use of non-GM original equipment wheels may cause:

Damage to the wheel bearing, the wheel fasteners and the wheel
Tire damage caused by the modified clearance to the adjacent vehicle components
Adverse vehicle steering stability caused by the modified scrub radius
Damage to the vehicle caused by the modified ground clearance
Speedometer and odometer inaccuracy

Replace the wheel, the wheel studs and the wheel/nuts, or the wheel bolts if applicable, if any of the following conditions exist:

The wheel has elongated bolt holes.
The wheel/nuts, or bolts if applicable, loosen repeatedly.

Steel wheel identification is stamped into the wheel near the valve stem.

Aluminum wheel identification is cast into the inboard side of the wheel.