LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Front Suspension) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the engine protection shield. Refer to Engine Protection Shield Replacement .
    3. Fig 1: Insulators & Stabilizer Shaft
    GM793300Courtesy of GENERAL MOTORS CORP.
  3. Remove the insulator clamp bolts.
  4. Remove the clamps.
  5. Remove the insulators.
  6. Inspect all of the parts for wear and damage.
scientia non olet · About LEMON Manuals