LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Front Suspension) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Shaft With Insulators
    GM793301Courtesy of GENERAL MOTORS CORP.
  1. Place the insulators on the stabilizer shaft with the slits facing toward the front of the vehicle.
    2. Fig 2: Insulators & Stabilizer Shaft
    GM793300Courtesy of GENERAL MOTORS CORP.
  2. Install the insulators to the stabilizer shaft.
  3. Install the stabilizer shaft.
  4. Install the clamps over the insulators and the stabilizer shaft.
    5. NOTE: Refer to Fastener Notice .
  5. Install insulator clamp bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  6. Install the engine protection shield. Refer to Engine Protection Shield Replacement .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals