LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Front Suspension) >> Repair Instructions >> Shock Absorber Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The front shock absorbers of the vehicle are multifunctional. In addition to contributing to a smooth ride they also provide the only stop to the front suspension when fully extended. Therefore, when servicing the shock absorber, service replacement shock absorbers must be equivalent to original shock absorbers in both extended length and strength. Use of shocks not complying to original equipment or strength could result in suspension over-travel or shock breakage. Suspension over-travel may result in suspension component breakage.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Shock Absorber & Tennon End
    GM793302Courtesy of GENERAL MOTORS CORP.
  2. Hold the tennon end with a wrench while removing the nut.
  3. Remove the nut.
    4. Fig 2: View Of Upper Insulator & Pilot Ring (4WD)
    GM477707Courtesy of GENERAL MOTORS CORP.
  4. Remove the upper insulator (1). Do not discard the plastic pilot ring (2).
    5. Fig 3: Shock Absorber Mounting Bolt At Lower Control Arm
    GM353965Courtesy of GENERAL MOTORS CORP.
  5. Remove the shock absorber mounting bolt (2) and nut (3).
  6. Remove the shock absorber.
scientia non olet · About LEMON Manuals