LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Front Suspension) >> Repair Instructions >> Lower Control Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the stabilizer shaft links from the lower control arm. Refer to Stabilizer Shaft Link Replacement .
  4. Remove the wheel drive shaft. Refer to Wheel Drive Shaft Replacement .
  5. Remove the shock absorber lower nut and the bolt. Refer to Shock Absorber Replacement .
  6. Remove the torsion bars. Refer to Torsion Bar Replacement .
  7. Remove the lower ball joint stud nut. Discard the nut.
    8. Fig 1: Lower Ball Joint & Steering Knuckle
    GM675143Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the lower ball joint stud from the steering knuckle using J 43631  (1) and the J 45851  . See Special Tools .
    9. Fig 2: Lower Control Arm Bolts
    GM793280Courtesy of GENERAL MOTORS CORP.
  9. Remove the lower control arm nuts and the washers.
  10. Remove the lower control arm bolts.
scientia non olet · About LEMON Manuals