LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Disc Brakes) >> Repair Instructions >> Disc Brake Splash Shield Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Disc Brake Splash Shield Components
    GM371077Courtesy of GENERAL MOTORS CORP.
  1. Install the splash shield.
  2. Install the hub and bearing assembly. Refer to Wheel Hub, Bearing, and Seal Replacement .
  3. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  4. Remove the safety stands.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals