LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Disc Brakes) >> Repair Instructions >> Disc Brake Hardware Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the caliper from the mounting bracket and support the caliper with heavy mechanic's wire or equivalent. DO NOT disconnect the hydraulic brake flexible hose from the caliper. Refer to Front Brake Caliper Replacement .
    4. Fig 1: View Of Disc Brake Pads & Brake Caliper Mounting Bracket
    GM369668Courtesy of GENERAL MOTORS CORP.
  4. Remove the disc brake pads from the disc brake caliper mounting bracket.
  5. Remove the disc brake pad retainers from the disc brake caliper mounting bracket.
  6. Inspect the disc brake hardware. Refer to Disc Brake Mounting and Hardware Inspection - Front .
    7. Fig 2: View Of Caliper, Pin, Boots & Caliper Mounting Bracket
    GM344219Courtesy of GENERAL MOTORS CORP.
  7. Remove the caliper pin boots (4) from the disc brake caliper mounting bracket (3).
scientia non olet · About LEMON Manuals