LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Disc Brakes) >> Repair Instructions >> Disc Brake Backing Plate Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the backing plate to the axle housing flange.
    2. Fig 1: View Of Backing Plate & Nuts - Rear
    GM370688Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the backing plate nuts.

    Tighten:  Tighten the backing plate bolts to 135 N.m (100 lb ft).

  3. Install the park brake shoe. Refer to Park Brake Shoe Replacement .
  4. Install the axle shaft. Refer to Rear Axle Shaft Replacement .
  5. Adjust the park brake shoe. Refer to Park Brake Adjustment .
  6. Install the rotor. Refer to Rear Brake Rotor Replacement .
  7. Install the park brake cable to the mounting bracket until the locking tabs snap into place.
  8. Install the rear park brake cable to the park brake actuator lever.
  9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  10. Lower vehicle.
  11. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
scientia non olet · About LEMON Manuals