LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Hydraulic Brakes) >> Repair Instructions >> Rear Brake Hose Replacement (Jounce) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Brake Hoses & Upper Bracket Bolt - Rear Jounce (W/JL4)
    GM793158Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Clean all dirt and foreign material from the brake hose and brake pipe fittings.
    3. IMPORTANT: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
  3. Use a backup wrench on the hose fitting, disconnect the brake pipe fitting from the brake hose, then cap or plug the brake pipe fitting end.
  4. Remove the brake hose upper bracket bolt.
    5. Fig 2: View Of Brake Hoses & Lower Bracket Bolt - Rear Jounce (W/JL4)
    GM793160Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
  5. Using a backup wrench on the hose fittings, disconnect the brake pipe fittings from the brake hoses (1), then cap or plug the brake pipe fitting ends.
  6. Remove the brake hose lower bracket bolt (2).
  7. Remove the jounce hoses.
scientia non olet · About LEMON Manuals