LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Hydraulic Brakes) >> Repair Instructions >> Master Cylinder Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the park brake and block the wheels.
    2. Fig 1: View Of Brake Pipes To Master Cylinder
    GM793135Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector from the brake fluid level sensor.
    3. IMPORTANT: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
  3. Disconnect the brake pipes from the master cylinder.
    4. Fig 2: View Of Master Cylinder & Mounting Nuts
    GM793137Courtesy of GENERAL MOTORS CORP.
  4. Plug the open brake pipe ends.
  5. Remove the master cylinder mounting nuts.
  6. Remove the master cylinder from the vehicle.
  7. Remove the master cylinder reservoir. Refer to Master Cylinder Reservoir Replacement .
scientia non olet · About LEMON Manuals