Torque Dampener Housing Removal
WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Torque Dampener Housing Removal
| Callout | Component Name |
|---|---|
|
CAUTION:
The valve body assembly must be removed prior to removing the torque dampener (with fluid pump) housing assembly. Failure to ensure this will cause severe damage to both fluid pump seal assemblies. Also, the load of the valve body pushing on the seals, which in turn push on the pump, may prevent proper pump installation into the case. Refer to Control Valve Assembly Removal . |
|
| 1 | A/Trans Fluid Pump Cover Bolt M8 x 1.25 x 25 (Qty: 12) |
| 2 | A/Trans Torque Dampener (w/Fluid Pump) Housing Assembly |
| 3 | A/Trans Torque Dampener Housing Gasket |