Input Shaft Installation

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Input Shaft

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Internal Gear Retaining Ring - 1st Position TIP: Use a NEW retaining ring. Do not reuse the old retaining ring.
2	Input Shaft
3	Internal Gear - 1st Position
4	Input Shaft Assembly
5	A/Trans Torque Dampener Clutch Fluid Seal Ring TIP: Use a NEW seal ring. Do not reuse the old seal ring.
6	Input Shaft Fluid Seal Ring TIP: Use a NEW seal ring. Do not reuse the old seal ring.
7	Input Shaft Thrust Bearing