Drive Motor with Generator Assembly Installation - 2nd Position
WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Drive Motor with Generator Assembly Installation - 2nd Position
| Callout | Component Name |
|---|---|
| 1 | Drive Motor (w/Generator) Assembly - 2nd Position
WARNING:
The generator motor weighs approximately 36 kg (80 lbs). Personal injury may result if you lift the generator motor improperly.
CAUTION:
Carefully feed temp sensor and resolver connector thru case opening or damage may occur. TIP: Install NEW O-Rings on motor while using holding fixture. |
| 2 | Generator Drive Motor Bolt M6 x 1.0 x 20 (Qty: 3)
CAUTION:
Refer to Fastener Caution . TIP: Use Dexron VI to aid with installation on O-Rings for motor. Tighten 9-13 N.m (80-115 lb in) Special Tool DT-48473 Motor Lift Plate |