Drive Motor with Generator Assembly Installation - 1st Position
WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Drive Motor with Generator Assembly Installation - 1st Position
| Callout | Component Name |
|---|---|
| 1 | Drive Motor (w/Generator) Assembly - 1st Position
WARNING:
The generator motor weighs approximately 36 kg (80 lbs). Personal injury may result if you lift the generator motor improperly.
CAUTION:
Carefully feed temp sensor and resolver connector thru case opening or damage may occur. TIP: Replace with NEW seals while motor is on holding fixture. |
| 2 | Generator Drive Motor Bolt M6 x 1.0 x 20 (Qty: 3)
CAUTION:
Refer to Fastener Caution . TIP: Use Dexron VI to aid installation on O-rings for motor. Tighten Tighten bolt to 9-13 N.m (80-115 lb in). Special Tool DT-48473 Motor Lift Plate |