LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 402 (Automatic Transmission - 2ML70 - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Drive Motor with Generator Assembly Cleaning and Inspection - 2nd Position

Drive Motor with Generator Assembly Cleaning and Inspection - 2nd Position

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Drive Motor With Generator Assembly - 2nd Position
GM1867786Courtesy of GENERAL MOTORS CORP.
Drive Motor with Generator Assembly Cleaning and Inspection - 2nd Position

Callout Component Name
CAUTION:

Do not use any type of solvent or cleaning agents in or on motor. Solvents or cleaning agents may damage the motor. Wipe with a clean towel that is lint free.

1 Generator Drive Motor Housing Seal
TIP:  Dex VI will continue to drain from the motor which is normal.
2 Resolver and Temp Sensor Connector
  • This is a critical connection, care must be taken.
  • Inspect for bent or broken pins.
3 Generator Motor Bearing
4 Generator Motor High Voltage Connections
TIP:  Inspect for arcing, broken plastic, or loose terminals.
5 Sun Gear Shaft Assembly - Third Position
  • The sun gear shaft may be pressed into the motor on some models and will not be serviced separately.
  • Inspect the splines on both ends of the shaft.