LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Antilock Brake System With TCS) >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Wheel Speed Sensor & Shim
    GM913375Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the electrical connector.
  3. Remove the wheel speed sensor retaining bolt.
    4. IMPORTANT: If a shim was removed when the wheel speed sensor was removed, it must be reinstalled to ensure proper operation.
  4. Remove the wheel speed sensor and shim if present.
scientia non olet · About LEMON Manuals