LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Seat Cushion Trim Cover and Pad Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Seat Cushion Front Nuts & Rear Plastic Holders
    GM378531Courtesy of GENERAL MOTORS CORP.
  1. Remove the front nuts (2) on the underside of the seat cushion.
    2. Fig 2: View Of Lumbar Cable And Front Seat Cushion Frame Components
    GM407184Courtesy of GENERAL MOTORS CORP.
  2. Unsnap the lumbar cable (6), disconnect the lumbar wire harness if equipped with power lumbar.
  3. Disconnect the electrical connectors.
    4. Fig 3: View Of Seat Cushion Front Nuts & Rear Plastic Holders
    GM378531Courtesy of GENERAL MOTORS CORP.
  4. Lift the seat cushion up off the rear plastic holders (1) on the underside of the seat cushion, and pull forward.
  5. Remove the seat switch bezel. Refer to Seat Switch Bezel Replacement .
    6. Fig 4: View Of Lumbar Cable And Front Seat Cushion Frame Components
    GM407184Courtesy of GENERAL MOTORS CORP.
  6. Remove the lumbar actuator (5).
    7. Fig 5: Unclipping/Clipping Seat Trim Cover
    GM386197Courtesy of GENERAL MOTORS CORP.
  7. Unclip the seat trim cover from the seat cushion frame.
    8. Fig 6: Seat Cushion Trim Cover
    GM386196Courtesy of GENERAL MOTORS CORP.
  8. Using a side motion, carefully separate the seat cushion trim cover from the seat cushion pad.
  9. Remove the pad from the seat cushion frame.
scientia non olet · About LEMON Manuals