Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Install the seat cushion pad to the seat cushion frame.

Fig 1: Seat Cushion Trim Cover

Courtesy of GENERAL MOTORS CORP.

Using a side motion, carefully pull the seat cushion cover onto the frame pad.

Fig 2: Unclipping/Clipping Seat Trim Cover

Courtesy of GENERAL MOTORS CORP.

Attach the seat trim cover to the seat cushion frame.

Fig 3: View Of Lumbar Cable And Front Seat Cushion Frame Components

Courtesy of GENERAL MOTORS CORP.

Install the lumbar actuator (5).
Install the seat switch bezel. Refer to Seat Switch Bezel Replacement .

Fig 4: View Of Seat Cushion Front Nuts & Rear Plastic Holders

Courtesy of GENERAL MOTORS CORP.

Place the cushion on the rear plastic holders (1) on the underside of the seat cushion, and push rearward.

Fig 5: View Of Lumbar Cable And Front Seat Cushion Frame Components

Courtesy of GENERAL MOTORS CORP.

Connect the lumbar cable to the underside of the seat cushion (6). Connect the lumbar wire harness if equipped with power lumbar.
Connect the electrical connectors.

Fig 6: View Of Seat Cushion Front Nuts & Rear Plastic Holders

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the front nuts (2) onto the studs on the underside of the cushion.
Tighten: Tighten the nuts to 21 N.m (15 lb ft).