LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Seat Back Recliner Handle Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Seat Back Recliner Handle
    GM378527Courtesy of GENERAL MOTORS CORP.
  1. Position the recliner handle on the side shield.
    2. NOTE: Refer to Fastener Notice .
  2. Install the screw retaining the recliner handle to the trim panel.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals