LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Rear Seat Cushion Cover and Pad Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Seat Cushion Cover, Frame & Foam Pad
    GM276675Courtesy of GENERAL MOTORS CORP.
  1. Install the seat cushion cover to the foam pad.
    2. NOTE: Refer to Fastener Notice .
  2. Install the center screw retaining the latch cover.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

  3. Engage the hook, and the loop-strips that are retaining the seat cushion cover (3) to the foam pad (4).
  4. Install the seat buckles, if removed.
  5. Connect the rear heater connector, if equipped.
  6. Install the hog rings, and/or the J-clips in order to retain the seat cushion cover to the seat cushion frame (8).
  7. Install the seat cushion plastic cover to the seat cushion frame.
  8. Install the rear passenger seat risers.
  9. Install the rear passenger seat to the vehicle. Refer to Rear Seat Replacement  or Rear Number 2 Seat Replacement .
scientia non olet · About LEMON Manuals