Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Install the seat belt guide (1) to the latch assembly, if removed.
- Install the spacer (2) to the latch assembly, if removed.
- Install the seat back latch assembly to the seat frame.
- Attach the recliner cables to the folding mechanism.
- Install the bolts (1, 2) that retain the latch assembly to the seat frame.
Tighten: Tighten the bolts to 45 N.m (33 lb ft).
- Install the screw (3) that retains the latch assembly to the seat frame.
Tighten: Tighten the screw to 25 N.m (18 lb ft).
- Install the seat back cover. Refer to Rear Seat Back Cushion Cover and Pad Replacement .
- Install the armrest, if equipped. Refer to Rear Seat Armrest Replacement .
- Install the rear seat to the vehicle. Refer to Rear Seat Replacement .
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.