LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Rear Seat Back Cushion Cover and Pad Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat from the vehicle. Refer to Rear Seat Replacement  or Rear Number 2 Seat Replacement .
  2. Remove the seat back folding cover, if necessary. Refer to Seat Back Cover Replacement - Rear Folding .
  3. Remove the armrest from the seat back, if equipped. Refer to Rear Seat Armrest Replacement .
    4. Fig 1: Rear Seat Back Components
    GM276555Courtesy of GENERAL MOTORS CORP.
  4. Remove the head restraints (1) from the seat back. Refer to Head Restraint Replacement .
  5. Remove the seat back plastic cover (10) from the seat back frame, if equipped.
  6. Release the J-clips from the seat back cover.
  7. Release the hook, and the loop strips retaining the seat back cover (2) to the foam pad (12).
  8. In order to ease removal, place a piece of cardboard between the seat back cover and the foam pad.
  9. Working from side to side, carefully lift the seat back cover from the foam pad.
scientia non olet · About LEMON Manuals