LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Lumbar Replacement - Front Seat >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat from the vehicle. Refer to Front Seat Replacement - Bucket .
  2. Remove the head restraint and guides. Refer to Head Restraint Replacement .
  3. Remove the seat back cover and pad. Refer to Front Seat Back Cover and Cushion Pad Replacement .
    4. Fig 1: View Of Bolster Paddles
    GM385757Courtesy of GENERAL MOTORS CORP.
  4. Drill out the rivet holes on the bolster paddles (1).
    5. Fig 2: Connecting Lumbar Wire
    GM381500Courtesy of GENERAL MOTORS CORP.
  5. Detach the lumbar clip from the top of the seat frame.
  6. Remove the lumbar wire from the bottom of the seat frame.
  7. Disconnect the electrical connectors to the motors.
  8. Remove the power lumbar/bolster assembly from the seat.
scientia non olet · About LEMON Manuals