LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Lumbar Replacement - Front Seat >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the power lumbar/bolster assembly on the seat.
  2. Connect the electrical connectors to the motors.
  3. Fasten the lumbar wire at the bottom of the frame.
    4. Fig 1: Connecting Lumbar Wire
    GM381500Courtesy of GENERAL MOTORS CORP.
  4. Attach the lumbar clip onto the top of the seat frame.
    5. Fig 2: View Of Bolster Paddles
    GM385757Courtesy of GENERAL MOTORS CORP.
  5. Install the rivets to secure the bolster paddles (1).
  6. Install the seat back cover and pad. Refer to Front Seat Back Cover and Cushion Pad Replacement .
  7. Install the head restraint and guides. Refer to Head Restraint Replacement .
  8. Install the seat in the vehicle. Refer to Front Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals