LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Head Restraint Support Cover Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Head Restraint Support Cover
    GM1386451Courtesy of GENERAL MOTORS CORP.
  1. Position the head restraint support cover over the head restraint rod.
  2. Insert the head restraint support cover through the slot in the seat back cover.
  3. Install the head restraint. Refer to Head Restraint Replacement .
scientia non olet · About LEMON Manuals