LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Head Restraint Retainer Replacement - Front Seat >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Slide up the seat back trim cover in order to gain access to the rear cardboard panel fasteners. Refer to Front Seat Back Cover and Cushion Pad Replacement .
    2. Fig 1: View Of Seat Belt Tower Cover/Panel Bolt
    GM378543Courtesy of GENERAL MOTORS CORP.
  2. Remove the panel fasteners. Pull back the panel in order to gain access to the bushings.
    3. Fig 2: View Of Head Restraint Retainers
    GM409498Courtesy of GENERAL MOTORS CORP.
  3. Remove the head restraint retainers from the seat back frame by squeezing the retaining tabs together at the base of the guide(s) and lifting up.
scientia non olet · About LEMON Manuals