LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Head Restraint Retainer Replacement - Front Seat >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Head Restraint Retainers
    GM409498Courtesy of GENERAL MOTORS CORP.
  1. Install the head restraint retainers by pressing into the seat back frame until the retaining tabs snap into place at the bottom of the frame opening.
    2. Fig 2: View Of Seat Belt Tower Cover/Panel Bolt
    GM378543Courtesy of GENERAL MOTORS CORP.
  2. Position the cardboard panel to the seat back frame and install the panel fasteners.
  3. Install the seat back trim cover. Refer to Front Seat Back Cover and Cushion Pad Replacement .
scientia non olet · About LEMON Manuals