LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Front Seat Trim Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the trim panel on the seat.
    NOTE: Refer to Fastener Notice .
    2. Fig 1: View Of Front Seat Trim Panel
    GM833483Courtesy of GENERAL MOTORS CORP.
  2. Install the trim panel (1) to the seat by pushing in until the retaining clips are locked in place.
  3. Install the screws retaining the seat back release handle and the seat recliner handle to the seat, if removed.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals