LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Front Seat Replacement - Bucket >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Bucket Seat
    GM363709Courtesy of GENERAL MOTORS CORP.
  1. Position the seat in the vehicle.
  2. Connect the electrical harness.
    3. NOTE: Refer to Fastener Notice .
  3. With the seat in the full forward position. Install the seat retaining rear bolts (1).

    Tighten:  Tighten the retaining rear bolts to 55 N.m (41 lb ft).

  4. Install the front seat retaining bolt cover (3).
  5. Move the seat to the full rearward position, and install the seat retaining front nuts (2).

    Tighten:  Tighten the nuts to 55 N.m (41 lb ft).

scientia non olet · About LEMON Manuals