LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Front Seat Back Hinge and Recliner Mechanism Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat from the vehicle. Refer to Front Seat Replacement - Bucket .
  2. Remove the seat trim panel. Refer to Front Seat Trim Panel Replacement .
  3. Remove the seat cushion frame. Refer to Front Seat Cushion Frame Replacement .
  4. Remove the seat back frame. Refer to Front Seat Back Frame Replacement .
    5. Fig 1: View Of Outboard Pivot Bolt
    GM381498Courtesy of GENERAL MOTORS CORP.
  5. Remove the outboard pivot bolt.
    6. Fig 2: View Of Seat Back Folding Mechanism & Bolts
    GM378534Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolts holding the seat back folding mechanism.
    7. Fig 3: View Of Front Recliner Cable, Folding Mechanism & Bolts/Screws
    GM396820Courtesy of GENERAL MOTORS CORP.
  7. Unsnap the recliner cable (1) from the folding mechanism (3).
  8. Remove the front recliner attachment bolts (4).
  9. Remove the recliner screw (5).
    10. Fig 4: View Of U-Channel
    GM381469Courtesy of GENERAL MOTORS CORP.
  10. Remove the U-channel (1).
  11. Remove the drive cable, if equipped with a power recliner.
  12. Disconnect the recliner cable from the recliner mechanism.
  13. Remove the recliner from the seat frame.
scientia non olet · About LEMON Manuals