LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Front Seat Back Hinge and Recliner Mechanism Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attach the recliner cable to the recliner mechanism.
  2. Install the drive cable, if equipped with a power recliner.
    3. Fig 1: View Of U-Channel
    GM381469Courtesy of GENERAL MOTORS CORP.
  3. Install the U-channel (1).
    4. Fig 2: View Of Front Recliner Cable, Folding Mechanism & Bolts/Screws
    GM396820Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the recliner screw (5).

    Tighten:  Tighten the screw to 10 N.m (89 lb in).

  5. Install the front recliner attachment bolts (4).

    Tighten:  Tighten the bolts to 53 N.m (39 lb ft).

  6. Attach the recliner cable (1) to the folding mechanism (3).
    7. Fig 3: View Of Seat Back Folding Mechanism & Bolts
    GM378534Courtesy of GENERAL MOTORS CORP.
  7. Attach the bolts holding the seat back folding mechanism.

    Tighten:  Tighten the bolts to 21 N.m (15 lb ft).

    8. Fig 4: View Of Outboard Pivot Bolt
    GM381498Courtesy of GENERAL MOTORS CORP.
  8. Install the outboard pivot bolt.

    Tighten:  Tighten the bolt to 35 N.m (26 lb ft).

  9. Install the seat back frame. Refer to Front Seat Back Frame Replacement .
  10. Install the seat cushion frame. Refer to Front Seat Cushion Frame Replacement .
  11. Install the seat trim panel. Refer to Front Seat Trim Panel Replacement .
  12. Install the front seat in the vehicle. Refer to Front Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals