LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Front Seat Back Frame Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat from the vehicle. Refer to Front Seat Replacement - Bucket .
  2. Remove the head restraint and guides. Refer to Head Restraint Replacement .
  3. Remove the seat trim panel. Refer to Front Seat Trim Panel Replacement .
    4. Fig 1: View Of Lumbar Cable And Front Seat Cushion Frame Components
    GM407184Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the lumbar cable (6) underneath the seat cushion. Disconnect the lumbar wire harness if equipped with power lumbar.
  5. Remove the seat back trim cover and pad. Refer to Front Seat Back Cover and Cushion Pad Replacement .
  6. Remove the lumbar assembly or power lumbar/bolster assembly if equipped. Refer to Lumbar Replacement - Front Seat .
  7. Remove the seat belt retractor. Refer to Seat Belt Retractor Replacement - Left Front or Seat Belt Retractor Replacement - Right Front .
    8. Fig 2: View Of Inboard Pivot Bolt & Recliner Arm Attachment Bolts
    GM386187Courtesy of GENERAL MOTORS CORP.
  8. Remove the inboard pivot bolt (1).
  9. Remove the recliner arm attachment bolts (2).
  10. Remove the frame from the vehicle.
  11. Transfer all necessary components to the new seat back frame.
scientia non olet · About LEMON Manuals