LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Front Seat Back Cover and Cushion Pad Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attach the foam pad to the frame.
    2. Fig 1: Locating Retractor Tower Retaining Screw
    GM381472Courtesy of GENERAL MOTORS CORP.
  2. Install the seat belt tower.
    3. NOTE: Refer to Fastener Notice .
  3. Install the bolts which retain the seat belt tower cover.

    Tighten:  Tighten the bolts to 1.9 N.m (17 lb in).

    4. Fig 2: View Of Seat Belt Tower Cover/Panel Bolt
    GM378543Courtesy of GENERAL MOTORS CORP.
  4. Install the rear cardboard panel. Engage the panel fasteners.
  5. Install the seat back cover partially onto the top of the frame.
  6. Feed the seat belt and the seat belt bezel through the tower opening.
  7. Install the arm rest clip.
    8. Fig 3: Front Seat Back Cover
    GM381479Courtesy of GENERAL MOTORS CORP.
  8. Pull the rest of the cover down using a side-to-side motion.
  9. Install the armrests, if equipped. Refer to Front Seat Armrest Replacement .
  10. Install the head restraint retainers. Refer to Head Restraint Retainer Replacement - Front Seat .
  11. Fit the seat cover around the air bag cover.
    12. Fig 4: Lower Seat Belt Anchor Nut
    GM381493Courtesy of GENERAL MOTORS CORP.
  12. Pull the seat belt down through the seat cushion and install the outboard seat belt anchor nut.

    Tighten:  Tighten the nut to 53 N.m (39 lb ft).

  13. Install the seat trim panel. Refer to Front Seat Trim Panel Replacement .
  14. Install the head restraints. Refer to Head Restraint Replacement .
  15. Push on the seat cover. Ensure that the cover is retained by the velcro in the seat cushion.
  16. Connect the J-strip at the bottom of the seat.
scientia non olet · About LEMON Manuals