LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Front Seat Adjuster Track Finish Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Adjuster Track Cover (Front)
    GM389598Courtesy of GENERAL MOTORS CORP.
  1. Install the track cover on the seat.
  2. Snap on the rear tabs, then the front tabs of the track cover.
  3. Install the seat in the vehicle. Refer to Front Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals