LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Trim, And Upholstery) >> Repair Instructions >> Front Seat Adjuster Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the memory module, if equipped. Refer to Memory Seat Control Module Replacement .
    2. Fig 1: View Of Seat Belt Buckle, Nut & Electrical Connection
    GM381486Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the inboard seat belt buckle and nut (1).

    Tighten:  Tighten the nut to 53 N.m (39 lb ft).

  3. Connect the electrical connection (2).
  4. Install the seat adjuster track cover. Refer to Front Seat Adjuster Track Finish Cover Replacement .
  5. Install the seat back hinge/recliner mechanism. Refer to Front Seat Back Hinge and Recliner Mechanism Replacement .
  6. Install the seat back frame to the seat adjuster. Refer to Front Seat Back Frame Replacement .
  7. Install the seat cushion frame to the seat adjuster. Refer to Front Seat Cushion Frame Replacement .
  8. Install the seat trim panel. Refer to Front Seat Trim Panel Replacement .
  9. Install the seat in the vehicle. Refer to Front Seat Replacement - Bucket .
  10. If the vehicle is equipped with memory seats, calibrate the seat. Refer to Memory Seat Calibration .
scientia non olet · About LEMON Manuals