Throttle Body Assembly Installation

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Throttle Body Assembly

GM1401966

Courtesy of GENERAL MOTORS CORP.

CAUTION:

Refer to Fastener Caution .

Install the throttle body studs, as required. Tighten the throttle body studs to 6 N.m (53 lb in).

NOTE:

DO NOT use the throttle body gasket again. Install a NEW gasket during assembly.

Install the throttle body gasket (509) to the intake manifold. Align the locating tab of the gasket with the notch in the manifold.
Install the throttle body (508), bolts (538), and nuts (507). Tighten the throttle body nuts and bolts to 10 N.m (89 lb in).