LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Suction Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
    2. Fig 1: Discharge Hose & A/C Compressor
    GM798935Courtesy of GENERAL MOTORS CORP.
  2. Remove the suction hose mounting bolt (2) from the A/C compressor (4).
  3. Remove the suction hose (1) from the A/C compressor (4).
    4. Fig 2: Suction Hose & Accumulator
    GM798937Courtesy of GENERAL MOTORS CORP.
  4. Remove the suction hose nut (1) from the accumulator (3).
  5. Remove the suction hose (2) from the accumulator (3).
  6. Remove the suction hose (2) from the vehicle.
  7. Discard all of the used sealing washers.
  8. Cap all of the A/C system openings.
scientia non olet · About LEMON Manuals