LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Recirculation Door Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the HVAC module assembly. Refer to HVAC Module Assembly Replacement .
  2. Remove the wiring harness from the recirculation housing (1).
  3. Remove the screws from the upper recirculation housing (1).
    4. Fig 1: View Of Upper Recirculation Housing And HVAC Module Assembly
    GM826727Courtesy of GENERAL MOTORS CORP.
  4. Remove the upper recirculation housing (1) from the HVAC module assembly (2).
  5. Disconnect the electrical connector from the recirculation actuator (1).
  6. Remove the screws from the recirculation actuator (1).
    7. Fig 2: View Of Recirculation Actuator & Recirculation Housing
    GM826725Courtesy of GENERAL MOTORS CORP.
  7. Remove the recirculation actuator (1) from the recirculation housing (2).
    8. Fig 3: Recirculation Door And Recirculation Housing (Visteon)
    GM826726Courtesy of GENERAL MOTORS CORP.
  8. Remove the recirculation door (1) from the recirculation housing (2).
scientia non olet · About LEMON Manuals